Technical Data; Installation - IB RUBINETTERIE BOLD B1 209 Fitting Instructions Manual

EN

TECHNICAL DATA

Minimum dynamic pressure:_________________________________________________________0.5 bar
Maximum operational pressure:________________________________________________________5 bar
Recommended operational pressure:_________________________________________________1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature:_______________________________________________________80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fi ne in time, must ensure compliance with the
mode of installation and maintenance described in this booklet. Relying on a qualifi ed plumber.
Make sure that the system is free from all debris and impurities existing.

INSTALLATION

Fig. 1-2: Make a hole into the wall with a minimum measure of 80 mm - 3.15 in, 70 mm – 2.75,
and MIN 63 mm - 2.48 in, MAX 73 mm - 2.87 in depth.
N.B.: The minimum and maximum measure have to be considered in relation to the fi nished
wall, cladding included.
Fig. 2: Fix the body to the fi xing plate.
Fig. 4 - 5 - 6: Fix the recessed body taking in consideration the perpendicularity, both vertical
and horizontal, by using a spirit level. Connect the body to the hydric system. It's recommen-
ded to use hemp or PTEF for granting the endurance.
After connecting the body to the system, turn on the stopcocks and check that the mixer tap
unit operates correctly. Keep the tap pressurised for a few minutes checking eventual leaks.
Fig. 7: Reduce the hole into the wall leaving a Ø45 mm - 1.77 in diameter.
Fig. 8: Insert the body on the recessed part, by inserting the plate.
Fig. 9: Fix the body by screwing the grains.
CLEANING
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and
dry them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid
detergents which contain corrosive or acidic substances, abrasive sponges, swab with metallic
strings because they could irreversibly compromise the surfaces.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE
IB RUBINETTERIE FROM ANY WARRANTY OBLIGATION.