Makita TD022D Series Instruction Manual page 6

NOTICE:
Change the direction only after the tool
comes to a complete stop. Changing the direction
of rotation before the tool stops may damage the tool.
To start the tool, first move the lock lever to the
unlocked position to release the switch.
► 1 . Lock lever 2. Switch
And then turn the switch to A side for clockwise rotation
or to B side for counterclockwise rotation.
Tool speed is increased by increasing rotation angle on
the switch. Release the switch to stop.
A
B
► 1 . Switch
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp only, first move the lock lever to the
unlocked position . And then rotate the switch to the A
or B side a little.
Release the switch to turn off the lamp.
1
2
B
A
1
► 1 . Lamp 2. Lock lever 3. Switch
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
Use only driver bit/socket bit that has inserting portion
shown in the figure. Do not use any other driver bit/
socket bit.
For tool with shallow driver bit hole
A=12mm
B=9mm
For tool with deep driver bit hole
A=17mm
B=14mm
A=12mm
B=9mm
6 ENGLISH
3
1
Use only these type of driver
bit. Follow the procedure
1. (Note) Bit-piece is not
necessary.
To install these types of driver
bits, follow the procedure 1.
To install these types of driver
bits, follow the procedure 2.
(Note) Bit-piece is necessary
for installing the bit.
2
A
B