ASCOM UPAC Series Installation And Operation Manual page 63

Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
The storage settings are divided into basic settings and advanced settings. With the basic
settings, it is possible to store activities based on set priority. This concerns messages,
messages with confirmation, interactive messages and responses on messages, all other
types of activities will be stored. In the advanced settings, it is possible to configure
whether or not to store depending on receiver/sender, and type of activity.
Basic Filter Settings
All check boxes for priority are selected as default, which means that all messages will be
stored. The different priorities are:
• Low
• Normal
• High
• Alarm
Note: Alarm refers to the message priority Alarm.
• Discard Messages with specified Priority
1 Clear the check boxes for message priorities that are not to be stored.
2 Click "Save".
Advanced Filter Settings
Click "Advanced Settings" to open the page. It is possible to discard or to store activities
sent from/to an IP address and a service. It is also possible to select specific activities to be
discarded regardless of sender/receiver.
2008-06-05/ Ver. B
Figure 76.
TD 92483GB
58