Troubleshooting Guide - Aiwa AW-LED40X6FL Operation Manual

Troubleshooting Guide

When you meet the following common problems, you might diagnose and get the
solutions without contacting with the technicians.
Symptoms
No picture, no sound,
and no indicator light on
Picture and sound with
abnormity
Picture is spotted or with
snow
No picture, no sound
and indicator light is
green/blue
Blue screen, AV is
displayed
No sound
HDMI source, with snow
pixel of full screen
The remote control does
not work
Troubleshooting
Possible Reason
1.The power cord is not plugged in
2.The power is off
1.Contrast, sharpness, and colour
are set improperly
2.Color system is set improperly
3.Sound system is set improperly
Signal source is low-grade or the
signal cord is in a lower quality
Volume is in the minimum value or
TV is in mute mode.
The signal cable is not correctly
connected.
There is no signal input or the video
cable is not connected or
incorrectly connected
There is no audio signal input or
audio cable is not connected
correctly
The source generate is not
standard
Batteries are improperly installed or
exhausted
1. Make sure the positive
2.Check if there is a loose
3.Replace the batteries
31
Solutions
1.Plug the power cord in
2.Turn the power on
1.Adjust the value of
Contrast, sharpness, and
colour
2.Set the Color system to
the country broadcasting
standard
3.Set the Sound system to
the country broadcasting
standard
Use the qualified signal cord
Adjust the value of volume
Connect the signal cable
correctly
Connect the video cable
correctly
Connect the audio cable
correctly
Plug the HDMI cable again
and the negative
polarities are correct.
contact between the
batteries and the springs