Advertisement
S
W
F
UNRISE
HISPURR
AN
IMPORTANT SAFEGUARDS
Please read all instructions before installing or using this product. Retain this guide for future reference .
WARNING! Disconnect power to all circuits in electrical box before installation.
Installation
1. Disconnect power at circuit breaker to avoid electrical shock or damage to unit.
2. Disconnect wires from existing fan wall switch.
3. Connect BLACK wire from Sunrise Whispurr unit to fan motor lead using wire nut (provided).
4. Connect BLACK wire from Sunrise Whispurr unit to 120VAC hot wire using wire nut (provided).
5. Attach decorator-style faceplate (not provided) to metal strap with two screws (not provided).
6. Restore power.
7. For fans equipped with built-in variable speed devices:
These devices must be set at their MAXIMUM SPEED for proper operation. Adjustments to their set-
tings must only be made with Sunrise Whispurr in HIGH position. Follow these steps:
a. Adjust Sunrise Whispurr slider to HIGH position.
b. Adjust fan's built-in control to MAXIMUM speed.
c. Adjust Sunrise Whispurr to lowest speed setting (first position above OFF).
d. Check fan for minimum speed to ensure fan does not stall.
If further adjustment is required, repeat steps A through D.
8. After installing Whispurr unit and setting motor to highest speed, discontinue use of the fan's pull-
chain.
Figure 1: Wiring Diagram
HOT
BLACK
BLACK
NEUTRAL
2
C
(ZWHIS)
ONTROL
Instructions
BLACK
To 120VAC Source
To Fan Motor Load
BLACK
LOAD
GROUND
Installation
Installation
Instructions
Figure 2: Installation
To NEUTRAL
Specifications
Operating Voltage:
Operating Temperature:
Dimensions:
ZWHIS
S
W
F
UNRISE
HISPURR
AN
MOTOR LOAD
1.5 AMP MAXIMUM
BLACK
Faceplate
BLACK
(not included)
ZWHIS
1.5 Amp, 120VAC, 60Hz
-10° to 60° C (-15° to 140° F)
1.68" (W) x 4.0" (H) x 1.37" (D)
C
(ZWHIS)
ONTROL
To Fan Motor
LOAD
To 120VAC Source
HOT
3
Advertisement
