Table of Contents
Advertisement
•
Loosen and remove the rod fixing ring nut (5) from the top of the lower tube (6).
Slide the decorative cap (7) from the base onto the tube. Replace and tighten
the rod fixing ring.
•
Then connect the tube assembly to the round base and positioned on the bal-
ance weight (11). From underneath, insert the washer and tighten the assem-
bly using the supplied angle screw.
•
Tighten until it is properly locked.
•
Slide the base decorative cap (7) down over the assembly.
•
Remove the lock nut from motor shaft. (anti-clockwise)
•
Place the rear grill on the motor housing, making sure to position the housing
lugs in the guide holes of the grill (handle at the top).
•
Firmly tighten (clockwise) the locknut to secure the rear grill.
•
Place the fan blade on the motor shaft by placing the notches in the blade in the
shaft passing through the motor shaft.
•
Tighten with the reverse nut (counterclockwise and lock the blade securely).
SFA23010_IM.indd 6
ASSEMBLY
6
25/03/2020 11:28
Advertisement
Table of Contents
