Installing Your Washing Machine; Selecting A Location; Removing The Shipping Bolts; Connecting The Water Supply Hose - Samsung WF9702N3C User Manual

Installing your washing machine

STEP 1

Selecting a location

Before you install the washing machine, make sure the location:
• Has a hard, level surface without carpeting or flooring that may obstruct ventilation
• Is away from direct sunlight
• Has adequate ventilation
• Will not be freezing (below 32 ˚F or 0 ˚C)
• Is away from heat sources such as oil or gas
• Has enough space so that the washing machine doesn't stand on its power cord
STEP 2

Removing the shipping bolts

Before installing the washing machine, you must remove all shipping bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Hold the bolt with the spanner and pull it through the wide section of the hole. Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Store the shipping bolts away safely in case you have to move the washing machine in the future.
Packaging materials can be dangerous to children; keep all packaging material (plastic bags,
polystyrene, etc.) well out of the reach of children.
WARNING
STEP 3
Adjusting the Levelling feet
When installing your washing machine, ensure that the power plug, the water supply and the drain are
easily accessible.
1. Slide the washing machine into position.
2. Level your washing machine by turning the levelling feet in and out as necessary by hand.
3. When your washing machine is level, tighten the nuts using the wrench supplied with your washing
machine.
STEP 4
Connecting the water and drain

Connecting the water supply hose

1. Take the L-shaped arm fi tting for the cold water supply hose and connect it to the cold water supply
intake on the back of the machine. Tighten by hand.
The water supply hose must be connected to the washing machine at one end and to the water tap at
the other. Do not stretch the water supply hose. If the hose is too short, replace the hose with a longer,
high pressure hose.
2. Connect the other end of the cold water supply hose to your sink's cold water tap and tighten it by hand.
If necessary, you can reposition the water supply hose at the washing machine end by loosening the fi
tting, rotating the hose, and retightening the fi tting.
For selected models with an additional hot water intake:
1. Take the red L-shaped arm fi tting for the hot water supply hose and connect it to the hot water supply
intake on the back of the machine. Tighten by hand.
2. Connect the other end of the hot water supply hose to your sink's hot water tap and tighten it by hand.
3. Use a Y-piece if you only want to use cold water.
STEP 5
Powering your washing machine
Plug the power cord into a wall sockets, an AC 220-240V / 50Hz approved electrical outlet protected by a
fuse or circuit breaker.
4_ Installing your washing machine
WF9702N3-02763G_EN.indd 4 2011-2-12 11:33:34