Table of Contents
Advertisement
Available languages
Available languages
M
L
K
J
I
H
Disassembly/assembly
Remove the splash guard lid
1
Press the release
downwards.
2
B
Raise the drive arm
upward, until it engages.
3
A
On first disassembly:
Remove the mixing attachments
stored in the bowl
.
J
Turn the bowl
counter-clockwise.
4
J
The bayonet fitting is released.
Remove the bowl
from the holder
5
J
If a mixing attachment is fitted:
Push the mixing attachment upwards against the spring.
6
7
Turn the mixing attachment one ¼ turn clockwise.
The bayonet fitting is released.
Remove the mixing attachment from the drive shaft.
8
7
6
8
•
The attachment can be assembled using the same steps
in reverse order.
In order to fold the drive arm back down again, you
Info:
must first press the release.
LCD
display D
•
In the top line of the LCD display, the processing time
elapsed, the preset time selected, or the remaining time
left of the preset time is displayed in minutes and sec-
onds.
•
In the bottom line, the currently set speed level (
is displayed as a bar diagram and in decimal format.
Subject to technical changes without notice; no responsibility is accepted for the accuracy of this information.
A
B
C
D
E
F
G
.
L
click
.
H
0 - 12
+ and - buttons
D
By pressing the + and - buttons, you can pre-set a time
for processing, which is then displayed on the LCD display:
•
0 - 20 min in 30 s steps
•
20 - 90 min in 5 min steps
Info:
•
The time setting 20 - 90 min is only of relevance for the
and
Timer
Stopwatch
•
You can reset the preset time by simultaneously pressing
the + and - buttons to
Rotary knob for speed
With the rotary knob, you can set the speed levels
and start or stop the appliance.
CAUTION Rotating parts can cause injury!
•
Processing starts immediately once the knob is turned
from position
!
0
•
If you turn the rotary knob to position
ing, processing stops and the elapsed processing time
or the remaining time left of the preset time is set to
.
00:00
•
You can change the speed level at any time.
PAUSE/START
button F
•
By pressing the PAUSE/START button, you can stop and
restart the currently running processing and the
and
functions.
Stopwatch
•
The time displayed on the LCD display is stopped by
pressing the PAUSE/START button and continues to run
once the button is pressed again.
Accessory
connector M
All original Jupiter attachments can be fitted to the acces-
sory connector using the adapter supplied.
•
Remove the cover from the accessory connector
store it in holder
.
C
•
Fit the supplied adapter to the accessory connector
(bayonet fitting, ¼ turn counter-clockwise).
)
functions (see page 8)
.
00:00
setting E
during process-
0
0 - 12
Timer
and
M
7
Advertisement
Table of Contents
