Installation - Midland Cardo BT Rider FM Instruction Manual

Attaching and removing the BT Rider FM from your helmet

Installation

The installation is very simple:
• The clamp serves as the base for the communication unit and must
be attached to your helmet before using the device.
• Use the enclosed Allen Wrench to loosen the 2 screws of the clamp
(Picture 1). Then slide the back-plate of the clamp between the
internal padding and the external shell of the helmet (Picture 2). In
case the external shell of the helmet is too thick, use the optional
extension pad.
As a special accessory, for some helmets a special clamp with extra
long microphone boom is available.
Picture 1
back-plate
• Before fastening the screws, make sure to adjust the clamp's location
to an ideal position, i.e. to the spot where the attached speaker sits
opposite your ear and the microphone is located in front of your
mouth (Picture 3). You may need to re-position the clamp repeatedly
until you identify the ideal spot. The speakers can be easily placed
into position and removed by means of the supplied velcro layer that
attaches to the inner padding of you helmet. In some countries it
may be not allowed to use speakers at both ears. In such cases
please attach both speakers at the same side, so that 1 ear can
remain free.
.
Picture 2
Picture 3
The microphone must be placed in in front of your mouth. It can also be
slightly adjusted to suit your helmet. Make some tests to find optimal
position.
• Once you have identified the ideal position for microphone and
speakers, use the Allen Wrench to fasten the clamp.
• Now slide the headset downwards along the sliding panel of the
clamp (Picture 4) until a sotf clicking sound indicates that the
headset is properly locked into place.
Picture 4
3