DITEC ENTREMATIC PASS24 Installation Manual page 3

DECLARATION OF CONFORMITY
EN
GENERAL SAFETY PRECAUTIONS
1. TECHNICAL DATA
Power supply
Absorption at rest
Absorption when detecting
Frequency
Output contact
Protection degree
Temperature
Max installation height
2. REFERENCE
3. INSTALLATION AND FUNCTIONING
NOTE: avoid putting any swaying objects - such as curtains, signs or plants
- in the detection area. Ensure that rain and snow cannot fall directly onto
the sensor or it doesn't detect them, and also that it is not directed towards
Outside the
detection area
Stand-by
4 OFF
Led
Output
relay
N.O.
24 V=
Inside the Outside the
detection area detection area
Stand-by
Motion
detection
ON OFF
4. ELECTRICAL CONNECTIONS
WARNING: The product must be connected to an extra-low voltage power
source (SELV) which is protected from overcurrent and shortcircuiting.
5. ADJUSTING THE DETECTION AREAS
Selecting the type of detection area.
Selecting the depth of the detection area.
NOTE: check the sensor does not detect the moving door wing.
Selecting the detection area
-
Adjusting the sensitivity
-
6. TROUBLESHOOTING
Problem Cause
-
All right reserved
4
-
-
-
Solution
- -
-
-