TECOM TS1066 Programming Manual page 42

3. On the Main tab, tick the
4. Configure any other settings required, such as
Computer
5. On the Comm Paths form, click the
set the IP address and Send/Receive port of the management software
computer.
6. Click the Save
The configured communications path can be used by CTPlus for further
configuration and management, or by TecomC4 for management. If required, set
up additional communications paths by repeating the steps in this section with a
different communications path.
Connecting CTPlus to NAC via IP
If desired, reconfigure the NAC panel record to use Ethernet communications
instead of USB. Using CTPlus, follow these steps:
1. Connect the NAC to the CTPlus computer using an Ethernet cable.
2. Click the Panels
the Panels form.
3. On the Panels form, select the NAC panel.
4. On the Definition tab, ensure the
communication path's
Security password, and the
communication path's
Enable
password.
button in the toolbar to save the Comm path record.
button on the Panel programming ribbon tab to open
Account
Security password
Computer
check box to enable the path.
Account code
Config Wizard
Account code is set to the
code, the Authentication type
is set to the
password.
and
button in the toolbar to
is set to