Ikelite 6890.2 Quick Manual

Straight Enhanced Magnifying Viewfinder
for DSLR and Mirrorless Housings
Product # 6890.2
Included in the Box
•
Viewfinder
•
Cap
•
Attachment tool
Important Notices
»
Do not expose the threaded end of the viewfinder to
water. The viewfinder is not waterproofed from the
threaded end.
»
Do not use alcohol or glass or surface cleaners on the
viewfinder.
»
It is recommended to remove the viewfinder from the
housing before packing for shipment or travel.
Installation and Use
Removing the Standard Viewfinder
Align the long, thin edge of the tool with the slots in the
1.
standard viewfinder.
2. Gently rotate the tool counter-clockwise to loosen and
remove the viewfinder. If additional leverage is required, a
screwdriver may be inserted in the tool. Apply downward
pressure on the tool to keep it from slipping out of the
slots while rotating.
3. Store the standard viewfinder in a cool, dry location.
Attaching the Magnified Viewfinder
1. Check that the o-ring, sealing surface, and threads
are clean and free of debris. It is not recommended to
lubricate the o-ring prior to installation.
2. Thread the viewfinder clockwise into the housing back by
hand.
From the inner side of the housing back, align the narrow
3.
end of the tool with the notches in the threaded end of the
viewfinder.
4. Orient the viewfinder to the landscape position to
correspond with the camera's viewfinder. Hold in this
position from the outside of the housing while completing
the next step.
5. Turn the tool counter-clockwise to tighten. The o-ring
will form a solid, dark line as it compresses and forms a
waterproof seal.