Samsung RSJ1FERS User Manual page 20

. Remove the filter's protective cap
and then position and insert the
filter into the filter housing.
. Slowly turn the water filter
clockwise 90º to align with the
indication mark on the cover,
locking the filter in position. Make
sure that the indicator is lined up
with the "lock" position. Remember,
do not over-tighten.
If your model contains wine shelf, you should remove the wine shelf before installing water
filters.
Removing any residual matter inside the water supply line after
installing filter.
1. Turn ON the main water supply & turn OFF the valve to the
water supply line.
. Run water through the dispenser until the water runs clear
(approx. 1L). This will clean the water supply system and
remove air from the lines.
. Additional flushing may be required in some households.
. Open the refrigerator door and make sure there are no
water leaks coming from the water filter.
A newly installed water filter cartridge may cause water
to briefly spurt from the water dispenser. This is due to
air getting into the line. It should pose no problem to
operation.
Check the amount of water supplied to the ice tray. (Optional)
1. Lift up the icemaker bucket and gently pull out of the freezer.
. When you press the Test button, the ice cube container is filled with water from the water
supply tap. Check to make sure the amount of water is correct(see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from
with in the main water pipes, not the refrigerator.
1
0_ setting up
ice maker
separation
of red cap
ice
feeler arm
Check the water level
test button

Cover filter
align the indication
mark with lock position
water