13
WHEELS, TIRES
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
–
Clean the thread of the wheel spindle and screw
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
–
Take the motorcycle off of the front wheel stand. (
B00744-10
–
Operate the front brake and compress the fork a few times firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Finishing work
–
Remove the rear of the motorcycle from the lifting gear. (
1
and mating surfaces
p. 175)
2
.
3
.
A
of the spacers.
2
.
M8
26 Nm
(19.2 lbf ft)
p. 79)
M8
15 Nm
(11.1 lbf ft)
p. 77)
106