Epson SC-F3000 Series User Manual page 43

SC-F3000 Series User's Guide (Excerpt)
C
Insert the funnel into the mouth of the bottle.
D
Remove the cap from the spout of the
pre-treatment liquid.
E
Open the lever to pour one liter of the
pre-treatment liquid into the bottle through the
filter.
Be careful not to overfill the filter with the
pre-treatment liquid, otherwise it will overflow.
Basic Printing
If there is only a small amount of pre-treatment
liquid remaining, tilt the cardboard container to
pour it in.
F
After pouring one liter, close the lever to stop the
liquid from flowing, and then replace the spout
cap.
If you want to filter more pre-treatment liquid,
replace the filter with a new one, and then repeat
the procedure from step 2.
G
You can now transfer the pre-treatment liquid in
the bottle to the intended container for use.
H
Store the cardboard pre-treatment liquid
container with the spout facing up as shown in
the illustration.
Cleaning and disposal
Rinse the used funnel and bottle with water, and then
wipe it dry with a soft, dry cloth.
When rinsing with tap water, make sure you rinse with
pure water at the end. If they are not rinsed with pure
water, components of the tap water can cause
coagulation.
43