Samsung SCX-5330N User Manual page 82

Message Meaning
Open Heat Error There is a problem
Cycle Power in the fuser unit.
Operation Not You are in the Add
Assigned Page/Cancel Job
operation, but there
are no jobs stored.
Over Heat Error There is a problem
Cycle Power in the fuser unit.
Paper Jam 0 Paper has jammed
Open/Close Door in the feeding area
of the tray.
Paper Jam 1 Paper has jammed
Open/Close Door in the fuser area.
Paper Jam 2 Paper has jammed
Check Inside in the paper exit
area.
Power Failure Power has turned off
then on and the
machine's memory
has not been back
up.
Retry Redial? The machine is
waiting for a
specified time
interval to redial a
previously busy
station.
Scanner locked The scanner module
is locked
Self Diagnostic The LSU (Laser
LSU Scanning Unit) in
your printer is
checking some
problems detected.
Self Diagnostic The engine in your
Temperature machine is checking
some problems
detected.
Send Error There is a problem
in SMTP
(AUTH)
authentication.
Suggested solutions
Unplug the power cord
and plug it back in. If the
problem persists, please
call for service.
Check the display to see
if there are any
scheduled jobs.
Unplug the power cord
and plug it back in. If the
problem persists, please
call for service.
Clear the jam. See page
14.2 and page 14.3.
Clear the jam. See page
14.3.
Clear the jam. See page
14.4.
The job which you were
trying to do before the
power failure must be
completely re-done.
You can press OK to
immediately redial, or
Stop/Clear to cancel the
redial operation.
Unlock the scanner and
press Stop/Clear.
Please wait a few
minutes.
Please wait a few
minutes.
Configure the
authentication setting.
14.9
Message Meaning
Send Error There is a problem
in DNS.
(DNS)
Send Error There is a problem
in POP3.
(POP3)
Send Error There is a problem
in SMTP.
(SMTP)
Send Error There is a problem
on the network
(Wrong Config)
interface card.
[Stop Pressed] Stop/Clear has
been pressed during
a fax transmission.
Tray 1 There is no paper in
Paper Empty the tray 1.
Tray 2 There is no paper in
Paper Empty the optional tray 2.
<Troubleshooting>
Suggested solutions
Configure the DNS
setting.
Configure the POP3
setting.
Change to the available
server.
Configure your network
interface card correctly.
Try again.
Load paper in the tray 1.
See page 5.5.
Load paper in the
optional tray 2. See page
5.5.