Turning On The Device; Change Of The Temperature Setting; Additional Defrosting; Operating Diodes And Thermostat Messages - Tefcold NOC60CC-P Instruction Manual

2.4. Turning on the device

1. Connect the device to the electric supply.
2. Turn on the main switch of refrigerant system (red switch – 1). The Carel/Dixell electronic contro-
ller with the programmed temperature is automatically switched on (setting). After max. 1 minute
the compressor is started.
3. Turn on the lightening (green switch – 2).
2.5. Operating the thermostat – Carel

Change of the temperature setting

1. Press SET button for 1 seconds; the set value will show at the display, after 2 seconds the value
will start flashing.
2. Increase or decrease the temperature using the  or  buttons to achieve the new value.
3. Press the SET button again to confirm the new temperature value.

Additional defrosting

The device works in automatic defrosting mode at 4–6 hours intervals. If you notice incomplete
defrosting, perform manual defrost, press and hold the

Operating diodes and thermostat messages

Compressor operation LED
Defrost LED – turns on when the device is in the process of defrosting.
Fig. 3
Fig. 4
– urns on when the compressor is running.
8
button for about 5 seconds.