Table of Contents
Advertisement
Problem
Severe air leakage.
(Note: Minimal escape of
air is often normal for air
tools.)
Excessive heat develops
in tool.
Tool continues to operate
after releasing throttle
lever.
Steel tool is loose.
Replacement parts
Service parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Please have the stock number and serial
number of your tool available when you call, so that we may serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from
JET.
Some parts are shown for reference only, and may not be available individually.
10
JCT-2610 Series Rivet Buster
Possible cause
Leakage from air inlet.
Leakage from throttle valve area.
Improper lubrication.
Worn internal parts.
Throttle valve pin or bushing is
damaged.
Blockage in valve area.
Steel shank does not match
retainer bushing.
Upper sleeve is worn.
Remedy
Change O-rings and check for
loosening of air inlet nut.
Check for wear of throttle valve
elements. Replace as needed.
Lubricate properly according to
instructions in this manual.
Inspect and replace as needed.
Inspect and replace elements as
needed.
Remove any foreign matter.
Use steel with correct shank type.
Replace upper sleeve.
Advertisement
Table of Contents
