10. The air tool must be properly lubricated before operating. Do not use this tool for other than its intended use. If used for other purposes, JET disclaims 11. Never start a percussion type air tool (chipper, any real or implied warranty and holds itself breaker, buster, etc.) without securing the...
Page 3
When not in use, disconnect tool from air 33. Do not lubricate the tool with combustible source. liquids, such as kerosene, diesel or jet fuel. 22. Shut off air supply and discharge any residual 34. Do not dispose of this tool with normal pressure from tool before removing hose, household waste.
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com.
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
10. Release throttle lever to stop tool. Lubricate shank of working steel with grease. Insert steel through rear of retainer. (Make JCT-2610 Series Rivet Buster ...
Always oil the tool and disconnect Tool Pressure air hose before storage. JET Air Tools operate on 70-to-100 psi (pounds Air system requirements per square inch) air pressure measured at the tool Use proper air hose size (refer to tool when the tool is operating.
Page 8
“Air Tool Oil,” or an ISO VG32 (SAE 10W) equivalent. Many JET air tools have integral oil When using multiple hoses, air hoses should be reservoirs, which should be kept filled when in-line larger than leader hose.
Page 9
Troubleshooting JCT-2610 series Rivet Busters Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET. Some parts are shown for reference only, and may not be available individually. JCT-2610 Series Rivet Buster ...
Page 11
#550610, JCT-2610 Rivet Buster 11in. – exploded view #550610, JCT-2610 Rivet Buster 11in. – parts list Index Part No. Description Index Part No. Description JCT2610-01 Handle JCT2610-13 Valve cover front JCT2610-HA Handle assembly (#1-10) JCT2610-15 Valve dowel pin JCT2610-03 Throttle lever JCT2610-16 Cylinder 6in.
Shop Tools; Warehouse & Dock products; Hand Tools; Air Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand.