Technics SU-R1000 Owner's Manual page 15

Analog audio cable
(not supplied)
: The illustration shows the example when
*
connecting with analog audio cable. You can
also connect the device with XLR cable.
You can connect the Blu-ray Disc player, etc. with
analog audio cable (not supplied) to this unit and
play back music.
1 Disconnect the AC power supply cord.
2 Connect this unit and a Blu-ray Disc
player, etc.
3 Connect the AC power supply cord to
this unit. ( 12)
4 Press the unit on/off button to the
[ ] position.
5 Press [LINE-XLR] or [LINE] to select
"LINE XLR"/"LINE1"/"LINE2".
• You can also select the input source by
turning the input selector knob on the unit.
6 Start playback on the connected
device.
When the recorder is connected to
this unit
When connecting a recording equipment to this
unit, use the analog audio cable (not supplied)
and connect REC IN terminal with the audio
output terminals of the connected equipment,
connect REC OUT terminals with the audio input
terminals of the connected equipment. ( 19)
• Press [REC IN] to switch the input source to
"REC IN".
*
Blu-ray Disc player, etc.
Using analog audio output device
Minimizing sound distortion
If sound distortion occurs when using the analog
audio input terminals, setting the attenuator to
"On" may improve the sound quality.
• The factory default is "Off".
1 Press [MENU].
2 Press [ ], [ ] repeatedly to select
"Attenuator" and then press [OK].
3 Press [ ], [ ] to select "On" and then
press [OK].
Reducing low frequency noise
Reduces the low frequency noise caused by the
warpage of record.
• The factory default is "Off".
1 Press [MENU].
2 Press [ ], [ ] repeatedly to select
"Subsonic Filter" and then press [OK].
3 Press [ ], [ ] to select "On" and then
press [OK].
15
Operations
(15)