Technics SU-R1000 Owner's Manual page 13

You can connect the CD player, etc. with coaxial digital cable (not supplied)/optical
digital audio cable (not supplied) to this unit and play back music.
Coaxial digital
cable
(not supplied)
CD player, etc.
Using coaxial digital cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a CD player, etc.
3 Connect the AC power supply cord to
this unit. ( 12)
4 Press the unit on/off button to the
[ ] position.
5 Press [COAX] to select
"COAX1"/"COAX2".
• You can also select the input source by
turning the input selector knob on the unit.
6 Start playback on the connected
device.
Note
• The digital audio input terminals of this unit can
only detect the following linear PCM signals.
For details, refer to the operating instructions of
the connected device.
- Sampling frequency:
Coaxial digital input
32/44.1/48/88.2/96/176.4/192 kHz
Optical digital audio
cable
(not supplied)
Using digital audio output device
Optical digital input
32/44.1/48/88.2/96 kHz
- Number of quantization bits:
16/24 bit
Using optical digital audio cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a CD player, etc.
3 Connect the AC power supply cord to
this unit. ( 12)
4 Press the unit on/off button to the
[ ] position.
5 Press [OPT] to select "OPT1"/"OPT2".
• You can also select the input source by
turning the input selector knob on the unit.
6 Start playback on the connected
device.
Adjusting the delay time of the
sound
Set to "Low Latency" to adjust the delay time of
the sound while "LAPC" is set to "On".
1 Press [MENU].
2 Press [OK].
3 Press [ ], [ ] to select "Normal"/"Low
Latency" and then press [OK].
• Depending on the track, it may not be effective
even when setting.
MQA decoding
®
An MQA file or stream can be decoded to deliver
the sound like the original master recording.
( 20)
Connections / Operations
Operations
13
(13)