Operation; Maintenance - Makita M4000 Instruction Manual

to the B direction (for the smaller number) to obtain low
speed and to decrease the air volume.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the nozzle (Fig. 3)
Align the pin protruding inside the nozzle with the notch
on the tool, push the nozzle to the blower outlet and then
securely turn the nozzle clockwise.
To remove the nozzle, turn counterclockwise and pull it
out.
Installing the sash nozzle (Fig. 4)
Sash nozzle is convenient for operation in a sash rail,
corner or tight place between cabinets. Secure the sash
nozzle by inserting it into the nozzle from the back of the
nozzle.
Install the nozzle with the attached sash nozzle. (Fig. 5)
Sash nozzle storage (Fig. 6)
When not in use, the sash nozzle can be conveniently
stored at the bottom of the tool as shown in the figure.

OPERATION

Blowing (Fig. 7)
Point the tool to the object to be blown off and turn on the
tool.

MAINTENANCE

CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
5