Table of Contents
Advertisement
Q7 When connecting to a computer-to-computer (Peer-to-Peer) network, I
cannot connect to another computer connected to the same computer-to-
computer network.
A1
Make sure that the security settings and network name of the computer-to-
computer (Peer-to-Peer) network is correct.
A2
Check the TCP/IP properties of the computers to be connected through the
computer-to-computer (Peer-to-Peer) network. All of the computers to be
connected through a computer-to-computer (Peer-to-Peer) network should be
configured so that their IP addresses are within the same subnet range.
- If the IP address is configured to DHCP (Obtain an IP address automatically) in
TCP/IP properties, IP address is configured within the same subnet range
automatically.
- If the IP address is configured to static IP in TCP/IP properties, select Use the
following IP address in the TCP/IP properties of the wireless adapter, configure
IP address:10.0.0.1~10.0.0.254, and Subnet mask: 255.255.0.0, and then try
again.
Q8 The network does not operate properly when both the wireless and the wired
network connections are simultaneously configured with the same IP
address.
A
You cannot use the wireless and the wired network connections using the same
IP address simultaneously. To use either the wireless or the wired network in turn
with the same IP address, you have to Disable whichever network device will not
be using in the network connection of the Control Panel.
Q9 The wireless LAN does not operate properly when there are other products
operating in the 2.4GHz band.
A
Devices compliant with IEEE 802.11b, operate in the public frequency, ISM
band. Therefore some channel interference may happen when there are other
devices using the same frequency band such as a wireless video transceiver, a
microwave oven, etc. If other products cause channel interference, change the AP
channel or stop using interfering devices.
Q10 An established wireless LAN connection is disconnected after 2~3 minutes,
and the connection is not recovered.
A1
This may be caused by channel interference. Change the channel of the AP, and
reconnect.
86 Users Manual
Advertisement
Table of Contents
