Table of Contents
Advertisement
Configuring the Password
Setting the Supervisor Password
By configuring a supervisor password, you can restrict system access to authorized
users only.
1. Select the Security menu in the System Setup. To enter System Setup, see "Using
System Setup" on page 64.
2. On the Set Supervisor Password item, press <Enter>.
3. Enter a password, press <Enter>, re-enter the password for confirmation, and
press <Enter> again.
4. When a message confirming the password configuration appears in the [Setup
Notice] window, press <Enter>.
Setting the User Password
You can configure user passwords so that other users can use the system.
On the Set User Password item, press <Enter>, and complete step 3-4 of Configuring
the Supervisor Password.
To use a fingerprint in the fingerprint sensor installed model, refer to the
supplied manual for the fingerprint sensor.
Before configuring a user password, a supervisor password must have been
configured.
Users can start the system with their user password, but cannot enter into the
System Setup.
Deactivating the supervisor password also deactivates the user password.
Configuring the Password 67
Advertisement
Table of Contents
