Advertisement
Setup Guide
See attached operation manual
for details.
• Controller
• Electroplated diamond file
1
Connecting the cords to back of controller
Main power cord
2
Remove the test horn
2-1
Turn the
protector sleeve
and remove it.
3
Tool installation
A
A
Electroplated
diamond file
(One piece tool)
Tighten firmly using attached two
wrenches
• Main power cord
• Ceramic fiber grindstone
Clamp with the tip holder
(Flat) for use.
Back of controller
②
①
B
B
Ceramic fiber
grindstone
1. Attach the tip holder to the handpiece and
tighten firmly with two wrenches.
2. Insert the ceramic fiber grindstone into the
tip holder( ① ) and tighten the set screw firmly
with the attached hexagon wrench( ② ).
①
Ultrasonic Polisher
Bundled items
• Handpiece
• Tip holder (Flat)
Handpiece
2-2
Remove the test horn
using attached two
wrenches.
②
• Wrench: 2 pcs.
• Fuse
• Hexagon wrench
• Tool box
• Tip holder (Round)
• Operation Manual
Align each
●
marks and
insert the plug.
Common to A and B
Insert the protector sleeve
into the handpiece and turn
it to install it.
*Always make sure that the protector
sleeve is installed before using the
handpiece, as using the handpiece
without it may result in burns.
①
②
• Foot switch
Foot switch
Advertisement
