Table of Contents
Advertisement
Instruction manual for: IIFF269177IDD | IIFF269177BSDD
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person
must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not work
Appliance freezes or cools too much Temperature is set too cold or the
The food is not frozen enough.
Heavy build up of frost on the door
seal.
Unusual noises
Side panels are hot
If the malfunction shows again, contact your point of purchase.
Imported by iiglo, Østre Kullerød 4,
N-3241 Sandefjord, Norway
Made in China | www.iiglo.com
Possible cause
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
appliance runs at SUPER modes.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat source. Please look in the installation
Door seal is not air tight.
Appliance is not level.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or the
wall.
This is normal. Heat exchanger is in
the side panels.
Solution
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to a
colder setting temporarily.
location section.
Carefully warm the leaking sections
of the door seal with a hair dryer (on
a cool setting). At the same time
shape the warmed door seal by
hand such thata it sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
14
Advertisement
Table of Contents
