Connecting Wireless Rear Speakers; To Hang The Wireless Receiver Module On The Wall; Resetting Wireless Communication - Samsung HT-TWP32 Instruction Manual

Connecting Wireless Rear Speakers

1
Connect your pair of wireless rear speakers, (L)
and (R), to the wireless receiver module.
Wireless Rear Speaker (R) Wireless Rear Speaker (L)
Gray
Blue
Back of Wireless receiver module
Caution
•
Do not connect the wireless rear speakers to the speaker outputs on the back of the main unit. Malfunction may result.
•
The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture.
•
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.

To hang the wireless receiver module on the wall

1
Separate wireless
receiver module stand.
3
Fix the wireless receiver
Fit the speaker
module on the wall. hole onto the screw
on the wall to hang
•
Fix the wireless receiver (mount) the speaker.
module firmly to prevent it
from falling.
13
2
Connect the power cord of the wireless
receiver module to the wall outlet and turn
the power "ON".
•
The Power Standby indicator will light up.
2
Fasten the screws (not supplied)
on the wall.
Note
•
Place the wireless receiver module at the rear of the listening
position. If the wireless receiver module is too close to the main
unit, some sound interruption may be heard due to interference.
•
If you use a device such as a microwave oven, wireless LAN Card,
Bluetooth equipment, or any other device that uses the same
frequency (2.4GHz) near the system, some sound interruption may
be heard due to interference.
•
The transmission distance of radio wave is about 33 feet, but may
vary depending on your operating environment. If a steel-concrete
wall or metallic wall is between the main unit and the wireless
receiver module, the system may not operate at all because the
radio wave cannot penetrate metal.

Resetting Wireless Communication

Reset the system if a communication failure occurs, or if the synchronizing signal indicator does not light up and the
"REAR CHK" message blinks on the main unit's display.
Reset the system while the main unit and the wireless receiver module (SWA-2000) are in Power Standby mode.
1
With the main unit turned off, press and
hold the remote control's REMAIN button
for 4 seconds.
•
Press the button until the volume control indicator
lights up blue. (The indicator will turn off in 1 second.)
2
With the wireless receiver module
turned on, use a ball point pen or a pair
of tweezers to press the RESET button
on the back of the unit 2 to 3 times.
•
The Standby/On LED on the front panel of the
wireless receiver module blinks 3 times.
3
Turn on the main unit.
•
The Link LED of the wireless receiver module is lit
and the setup is finished.
•
If Power Standby mode continues, repeat Steps 1 to
3 above.
Caution
•
Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.
•
In 2-CH mode, no sound will be heard from the wireless rear speakers.
RESET Button
Back of Wireless receiver module
14
GB