Activating The Alarms; Checking The Alarm Setting; Using The Snooze Function - Medisana 270103 Instruction Manual

2.5
Activating
the alarms
2.6
Checking the
alarm setting
2.7
Using the
snooze function
1. Press the Alarm1 button
button to activate Alarm 2. The alarm time is displayed. If AL1
and AL2 have both been activated, the alarm time nearest the
current time is displayed.
2. If you press the
alarm function is deactivated.
The alarm becomes active 30 minutes before the set time.
The brightness gradually increases to the level set for the alarm time. The
volume selected for the alarm time, increases from the start of the alarm
(when the alarm time is reached) to the set value within 60 seconds.
The regular alarm is only activated, if there are more than 30 minutes
between the time when the alarm is set and the time at which the alarm
is supposed to be triggered.
If there are less than 30 minutes between the time when the alarm is set
and the time at which the alarm is supposed to be triggered, the alarm
function will start 60 seconds before the setting time and the brightness
and volume increase to the set final levels within 60 seconds.
If an alarm is active, the buttons for radio
If you have set and activated an alarm but the alarm is not yet active, you
can use the button
1. Press the Quick Check button
volume are fast-forwarded to the set levels.
2. The set alarm time is then displayed for several seconds.
3. After that, the brightness and volume are reduced to zero again and
the Quick Check function ends.
4. Press the button
Check function.
If you have activated an alarm time, the countdown for it has already
started but the maximum level of brightness has not been reached, you
can use the button
1. If you press the Snooze button
alarm time, the alarm function (brightness and volume) stops until
the set alarm time. The brightness and volume then only need 1
minute to increase to the set levels before the alarm time.
to activate Alarm1 and the Alarm2
or button a second time, the corresponding
to check the settings of the alarm functions.
and the values for brightness and
again during the check to interrupt the Quick
for the snooze function.
in the 30 minutes before the set
2 Operation
and light are disabled.
GB
15