Positioning And Setup; Setting The Time; Setting The Alarms - Medisana 270103 Instruction Manual

2.2
Positioning
and setup
2.3
Setting
the time
2.4
Setting
the alarms
WARNING
Please ensure that the polythene packing is kept away
from the reach of children!
The plastic bag is a suffocation hazard if held over the
nose and mouth or pulled over the head!
1. Place the device on a solid and flat surface for use to ensure that it
cannot tip over or fall down.
2. Position the device about 40 - 50 cm away from your head, for
example, on a bedside table.
3. Connect the power supply unit to the socket marked "DC 12 V"
and connect the antenna to the "ANT" socket on the back of the
device. Connect the power supply unit to the power supply.
4. The time (12:00) appears in the display
Hint:
Unwind the antenna and fasten the end of it as high as possible to
optimise radio reception.
1. Press the Set button
display flashes every 0.5 seconds.
2. In this mode, you can set the time. The device quits this mode auto-
matically if you do not press any button for 10 seconds.
3. Press the and
ton to run quickly in either direction and let go to stop.
4. Press the Set button
(The first time you press the Set button
menu for setting the alarms (see 2.4).
1. Press the Set button
display .
2. Press the Set button
Alarm 1 (AL1) / Alarm 2 (AL2) / Zizz (temporary alarm). The device
quits this mode automatically if you do not press any button for 10
seconds.
3. Use the buttons
and confirm your selection with the Set button
example).
2 Operation
.
for about 3 seconds; the time on the
to set the minutes. Hold the but-
buttons
twice to quit the menu for setting the time.
for 3 seconds until the time flashes in the
a second time to open the menu for setting
or to choose the desired alarm
GB
you are taken to the
(take AL1 for
13