Connecting The Video Out To Tv - Samsung HT-DS470 Instruction Manual

1p~38p(DS470)-GB 9/16/04 9:35 AM

Connecting the Video Out to TV

Make sure that turn off and disconnect the plug from outlet before moving or installing the product.
In connecting to video, select one of following three methods that suits for TV and connect it.
IMPEDANCE SUBWOOFER : 4Ω
FRONT / CENTER / REAR : 4Ω
CENTER
SUBWOOFER
METHOD 1
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
METHOD 2
If you television is equipped with an SCART input, connect an Scart Jack (not supplied)
from the AV OUT jack on the back panel of the system to the SCART IN jack on your
television.
For using the SCART cable
• If Scart is equipped for your TV, set RGB-COMPOSITE selector
of the center unit to RGB. You can get a better picture quality by
using Scart setting.
• If Scart (RGB Input) is not equipped for your TV,
set RGB-COMPOSITE selector to COMPOSITE.
METHOD 3
If your television is equipped with Component Video inputs, connect a component video
cable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to the
corresponding jacks on your television.
•
When the Progressive scan mode is selected, the VIDEO and SCART outputs
Note
do not feed any signal. See page 14 to select Progressive Scan.
13
Page 16
METHOD 1
TV
VIDEO
IN
Composite Video ............... Good Quality
Scart ............... Better Quality
Component (Progressive Scan) Video ............... Best Quality
METHOD 3
COMPONENT SCART
IN IN
METHOD 2
RGB
COMPOSITE
RGB
COMPOSITE