Dell 7760 User Manual page 10

5 Laser
6 Freeze
7 Brightness +
8 Keystone adjustment
+
9 Brightness -
10 Keystone adjustment
-
11 Blank screen
12 Info
13 Video mode
14 HDMI
15 Enter
16 Left
17 Menu
18 Source
19 Volume up
10 About Your Dell Projector
Point the remote control at the screen, press
and hold the laser button to activate the laser
light.
WARNING:
when it is active. Avoid pointing the
laser at your eyes.
Press to pause the screen image, then press
"Freeze" again to resume normal projection.
Press to increase the brightness.
Press to adjust image distortion caused by
tilting the projector (+/-30 degrees).
Press to decrease the brightness.
Press to adjust image distortion caused by
tilting the projector (+/-30 degrees).
Press to hide/unhide the image.
Press to display the projector information.
The projector has preset configurations that
are optimized for displaying data
(presentation slides) or video (movies, games,
etc.).
Press the Video Mode button to toggle
between Presentation mode, Bright mode,
Movie mode, sRGB, or Custom mode.
Pressing the Video Mode button once will
show the current display mode. Pressing the
Video Mode button again will switch
between modes.
Press to choose HDMI 1 or HDMI 2 source.
Press to confirm the selection.
Press to navigate through the On-Screen
Display (OSD) Menu items.
Press to activate the OSD.
Press to switch between sources: VGA, HDMI
1, HDMI 2, Wireless Display, and LAN Display.
Press to increase the volume.
Do not look at the laser