Setup - Central Pneumatic 95810 Owner's Manual & Safety Instructions

Delayed or inadequate cleaning will permanently clog the Spray Gun.
Initial Set Up
read the ENTIrE IMpOrTANT SAFETY INFOrMATION section at the beginning of
this manual including all text under subheadings therein before set up or use of
this product.
Note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual.
Before Setup
1. This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
2. Before first use, clean the Airbrush using
a solvent-based thinner. If not removed,
the material used for testing and corrosion
prevention will contaminate paint.
Page 6
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
For technical questions, please call 1-888-866-5797.
3. The Metal Cup (28) has two uses. It
is used for excess correctly thinned
paint, and also for solvent when it
is time to clean the Airbrush.
4. The Metal Hook (30) can be attached to a
secure surface and used to hang the Airbrush
for drying, or when it is not being used.
Item 95810