Advertisement
Delayed or inadequate cleaning will permanently clog the Spray Gun.
OPERATING INSTRUCTIONS
read the ENTIrE IMpOrTANT SAFETY INFOrMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this
product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Workpiece and Work Area Set up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Route the air hose along a safe
path to reach the work area without
creating a tripping hazard or exposing
the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length
to allow free movement while working.
3. Before spraying, mask nearby
objects not being sprayed and lay
cloths (not included) on the floors.
paint preparation and Filling
manual. Improper adjustment can result in tool failure or other serious hazards.
Note: Proper paint mixture is essential.
Follow the manufacturer's directions.
Most paints will spray easily if
they are thinned properly.
1. Thin the paint according to manufacturer's
directions and mix thoroughly.
2. Carefully strain the paint through
a paint strainer or a piece of cheesecloth.
3. Fill the Jar to 3/4 full. Close the Jar.
4. Hold the Housing lightly in your hand and
push the tapered fitting on the lid of the
Jar into the base of the Housing. It is held
in place with friction and is not threaded.
Page 10
NOTICE
Clean the Spray Gun IMMEDIATELY after use.
TO prEVENT SErIOuS INJurY: Do not adjust or tamper with any
control or component in a way not specifically explained within this
For technical questions, please call 1-888-866-5797.
Finger
Lever
Air Inlet
Jar
Figure C: Components and Controls
5. Start the air compressor and set
the regulator to needed pressure.
Do not exceed maximum air pressure.
6. Test the consistency by spraying
on a piece of scrap material.
If it still appears too thick, add a very
small amount of thinner (not included)
and mix thoroughly. Use the proper
thinner for the type of paint.
Thin CAUTIOUSLY. Proceed slowly,
adding minimal amounts at a time.
DO NOT exceed the manufacturer's
thinning recommendations.
Adjustment
Screw
Nozzle
(under
Cap)
Item 95810
Hide quick links:
Advertisement
