Advertisement
While driving, cover must be completely flat and secure with all latches in the closed position OR
completely folded up (all panels) and secured at the cab. DO NOT DRIVE with cover partially opened.
Tonneau Cover Positions While Operating Vehicle
Prior to vehicle operation, tonneau cover MUST be properly secured.
CLOSED POSITION
All panels must be closed and FULLY LATCHED to tonneau side rail.
All panels must be flat and latches engaged
FOLDED UP POSITION
To drive with your cover in the folded up position, simply make use of the
provided tie down straps and buckles provided with your cover. Ensure BOTH
buckle clips are fully inserted into the buckle ends located on the front header
panel of the cover and adjust the straps to ensure the cover is secure during
vehicle operation. The clips should be secured in the storage position,
as shown in Figure 1, when not in use.
FLIPPED UP POSITION
A) Fold the cover open and lift it until its vertical or
past 90 degrees towards your truck cab. Then release
the prop rod that is attached to your rail. Fold the
prop rod over and position it firmly against the
vertical plate on the underside of your cover.
Then slide the prop rod locks downward
and tighten the knobs to lock into position.
Do this on both sides of the cover.
B) Your cover should be firmly in
position with little to no movement
once the prop rods are locked.
Additional Important Operating Tips
The bed cover MUST be free of foreign material including snow and ice
before opening panels.
Do NOT tow your vehicle from the rear with the bed cover on your truck.
Do NOT operate vehicle with objects on top of cover.
FAILURE TO FOLLOW THESE CAUTIONS MAY RESULT IN
SEVERE DAMAGE AND WILL VOID YOUR WARRANTY!
BAK Industries
• 1100 N. Glenstone Ave. Suite 140, Springfield, MO 65802 • 844-779-8986 • bakindustries.com
IMPORTANT
safe operation and use
IMPORTANT NOTICE
STORAGE
POSITION
FOR CLIP
FLIPPED UP: A
Remove any snow or foreign
matter before folding cover.
Do NOT tow your vehicle from the
rear with this cover on your truck.
FIGURE 1
FOLDED UP POSITION
FLIPPED UP: B
Part# 318A0029 Rev. 1.8.2020
© Laurmark Enterprise, Inc. 2020
Advertisement
