Advertisement
20
Install the prop rod.
Snap the knuckle end onto the bracket.
Check to see that the cover panel
22
latches make proper contact with
the side rails.
Adjust the cover
side to side by
loosening the knobs
tightened in Step 16,
adjust the cover to
maintain good
engagement, then
carefully open the
cover and re-tighten
the knobs.
DO NOT ATTEMPT TO DRIVE WITH THE TAIL PANEL
IN THE PARTIALLY OPEN POSITION!
BAK Industries
• 1100 N. Glenstone Ave. Suite 140, Springfield, MO 65802 • 844-779-8986 • bakindustries.com
IMPORTANT
safe operation and use
21
Clip the prop rod clip onto the cover rail.
23
Sometimes, your side seals of your cover
will appear to be wrinkled shortly after
initially installing the cover. To assist seals
in laying flat you can leave your truck in the
sun, or to expedite, just apply heat with a
hair dryer or heat gun.
Start by hooking the top
edge into the rail slot,
then slide the bottom
under the rail section.
One on both sides.
Clip the prop rod into
the clip for storage
when not in use.
Part# 318A0029 Rev. 1.8.2020
© Laurmark Enterprise, Inc. 2020
Advertisement
