BAK BAKFlip G2 Installation Sheet

TOOLS RECOMMENDED
9/16 Wrench or socket
7/8 Drill bit & drill (optional)
Philllips screwdriver
1
3
NOTE: Some drop in liners may require trimming
in the corners to fit the rail in the opening.
BAK Industries
• 1100 N. Glenstone Ave. Suite 140, Springfield, MO 65802 • 844-779-8986 • bakindustries.com
INSTALLATION SHEET
Any damaged or missing parts?
Parts will be shipped to you directly. Call 844-779-8986
Mon - Fri 8:30 am - 7 pm EST or email support@bakindustries.com
PARTS INCLUDED IN YOUR KIT
•
1 x Hard folding cover assembly
•
3 x D Shaped cab bumpers
•
1 x Bulkhead seal
(¾ x ¾ x truck width)
•
1 Pair rails (L&R)
•
2 x Drain hoses
•
2 x Prop rods
•
2 x Prop rod clips
If the truck does
not have a drop
in bedliner, install
the cab/bulkhead
seal (weather
strip). Wipe paint -
ed surface with
isopropyl alchol
before applying.
If the truck has a
drop in bedliner,
no seal will be
needed.
Make sure
the rail is
clamped
square as
shown.
Start at the
front, and
place the
first clamp
approx 6 to 9
inches back.
Part# 318A0029 Rev. 1.8.2020
1 HARDWARE BAG INCLUDING
•
6 x Clamps (8' ft trucks incl. 8 ea)
•
2 x Elevator bolt (w-large flat head)
•
4 x Rubber washers
•
2 x Large flat washers
•
2 x Lock washers
•
2 x Star knobs (thumb screws)
•
2 x Buckle ends
•
4 x Machine screws
•
4 x Threaded posts
SELECT SYSTEMS ONLY!
•
8 x Angle shims
•
2 x Spacer shims
2
4
Make sure the
clamp is inserted
all the way up
into the rail and
clamp teeth are
alinged to rail
slots to ensure
a secure grip.
Laurmark Enterprises, Inc., 2020
(not pictured)
Close tailgate.
Place BAKFlip rail
on truck bed with
silver bracket all
the way forward
and toward the
center of bed as
shown. Refer to
enclosed Spacing
& Shimming Sheet
for more details.
Rails should be
completely level.