Using The Cleaning Pads; How To Clean The Scrubbing Pads; Cleaning The Housing - Prolux CORE Operation Instructions Manual

n USING THE CLEANING PADS
To attach the pads/cloths, take the pad holder and set it on the ground. Make sure the white side is
upwards, then simply take you Prolux Core and set it on top of the pad holder. Firmly push down using the
Prolux Core's weight, you will feel and hear it snap in. Now with the pad holder properly attached all you
have to do is set the desired pad/cloth you want to use on the ground and set the Buffer on top of it. To
remove the cleaning pads/cloths from the buffer unit, simply detach the pad away from the pad holder
NOTE: To attach the Tile/Hard Floor scrubber please remove the pad holder. Installation for this pad
follows the same step as the pad holder.
HOW TO CLEAN SCRUBBING PADS
n
There are multiple sets of cleaning pads that are included with your buffer, when they become dirty, you
can simply take them off the buffer, and wash them by hand in your sink with warm water and for those
lightly soiled pads use a mild detergent. You can also use your washing machine, select a light duty cycle,
add mild detergent for those heavily soiled pads, and allow them to air dry.
NOTE: DO NOT PLACE IN THE DRYER.

CLEANING THE HOUSING

n
WARNING: Always switch off the appliance and disconnect it from the outlet before cleaning it.
ATTENTION: Do not use Alcohol, cleaning or scouring agents to clean your machine, as these may
damage the appliance. Clean the outside of the housing using only a slightly damp washcloth.
- 9 -