oventrop Regucor Series Quick Start Manual page 11

Illustr. 5.4 Installation of the angle pattern adapter
5. Screw the angle pattern adapter to the diverting
valve "Tri-D TR" (see illustr. 5.4)
Illustr. 5.5 Installation of the actuators
6. Mount the actuators (see illustr. 5.5).
Further procedure - Connection to the electronic
controller (exemplary for "Regtronic RS", other
controllers may also be used).
Tri-D-TR
R13
A
Tri-M-TR
Heat
R13
B
AB
generator
Illustr. 5.6 Cabling
!
DANGER
Danger to life due to electric shock!
– Electrical connections must only be carried out
by a qualified electrician.
– The following 5 safety regulations must be
observed during installation and cabling:
– Disconnect
– Protect against accidental restart
– Check that no voltage is present
– Earth and short-circuit
– (If necessary) Cover adjacent, live parts
– In case of damage to the insulation, switch off
power supply immediately and have repair
carried out.
– Never bridge or switch off fuses. The correct
amperage must be observed when replacing
fuses.
– Keep live parts away from moisture (risk of short
circuit).
!
WARNING
Electric shock!
Live components inside the controller casing.
– Completely disconnect (all poles) the appliance
from the power supply before opening the
casing.
7. Connect to the electronic controller.
Tri-D-
TR
R13
A
Tri-M-
Heat
TR R13
B
AB generator
11