Samsung DVD-HR773A User Manual page 22

connecting & setting up
COnnECTing THE HDD & DVD rECOrDEr
This section involves various methods of connecting the HDD & DVD RECORDER to other external components
and required initial setting modes.
You can connect your HDD & DVD RECORDER to the television using the SCART cable if the appropriate
input is available on the television.
1. Connect the RF cable as shown.
2. Connect one end of the SCART cable to the AV1 socket on the rear of the HDD & DVD RECORDER.
3. Plug the other end into the appropriate connector on the television.
4. Plug in the HDD & DVD RECORDER and TV
5. Turn on the HDD & DVD RECORDER and TV.
6. Press the inPUT SEL. button on your TV remote control until the Video signal from the HDD & DVD
RECORDER appears on the TV screen.
M
`
The RF cable connection of this product sends only signals of TV. You must connect SCART cable or Audio/Video
cables to watch a DVD from your HDD & DVD RECORDER.
`
TV mode : Press the TV/DVD button on the remote control, then "TV" will appear on the Front display (or turn off
HDD & DVD RECORDER).
Then you can watch programmes received through TV.
`
If you set "Power save mode" on and power off Recorder, TV channel signal from ANT OUT of DVD-Recorder may be
a little noisy.
So, in this case, set "Power save mode" off, then you see the clean channel in TV.
_ connecting & setting up
To anT in
To TV
rF Cable
To anT inPUT