Number Types; Operation; Registration - Advent Controls A5 Installation And Setup Manual

1.2

Number Types

When adding a telephone number to the system it can be set up as one of five different
telephone number types with each type having a specific purpose. There is space for 512
numbers (1024 on selected C4 PCBs) and each number can be set up as any type of num-
ber. For example you may wish to have 200 masters and 312 users.
Master Numbers
These numbers are used to make changes to the system including adding other numbers.
master me
Master 07000000000.
Text Numbers
These numbers are the recipients of power failure/restore SMS text messages. These num-
bers cannot access any of the board's command functions.
Text me
text 07000000000.
Call Numbers
Call numbers are dialled when the power has failed or is restored. Call numbers are dialled
before the sending of SMS text messages to the Text Numbers. They are dialled in the order
in which they are added. The numbers are dialled sequentially until a call is answered and
rejected.
Call 07000000000.
Call me
User Numbers
User numbers are able to operate the output relay only—used mainly for access control
applications. Master numbers already have access to the output relay.
Add me
Add 07000000000
*Jumper must be fitted or sender must be a master number to allow this
2.

Operation

2.1

Registration

A valid GSM Subscriber Identity Module (SIM) card must be present in the SIM holder for the
system to operate. Immediately on power up the system will attempt to register on the SIM
card on it's home network. Once registration has occurred LED1 will change from flashing
approximately once every second to a momentary flash once every two seconds. If the
LED1 continues to flash once every second for some time, the system cannot register the
SIM on the network. The system will restart should this occur. If the problem persists check
the antenna and strength of signal in your area/validation of the SIM card. Remove any PIN
numbers from the SIM card. Observe anti-static precautions when inserting the SIM.
sets the phone number sending the message as a master*
sets the phone number 07000000000 as a master phone
sends power failure/restore messages to sender*
sends power failure/restore messages to 07000000000
calls 07000000000 on power failure/restore
calls sender on power failure/restore*
sets sender as user number
allows 07000000000 to operate output relay