Mounting Location - Teleflex MV-2 Series Owner's Manual

CAUTION
!
Should it be necessary to re-
move the hanger plate from
the back of the control, DO NOT
remove the two (2) recessed
screws which retain the back of
the Gear Unit Assembly. Disas-
sembly of the gear unit could
result in loss of inner compo-
nents and incorrect re-assem-
bly.

Mounting Location

Page 5 of 10
Choose a mounting location for the control head which will pro-
v i d e c o m f o r t a b l e o p e r a t i o n o f t h e h a n d l e v e r, u n o b s t r u c t e d
movement of mechanism arms and a clear path for cables to engine.
Figure 6 shows the control dimensions and the recommended clearance behind
the mounting surface.
The recommended position for the control head is shown below. The vertical
center line of the hand lever should be in line with the front edge of the seat and
the hand lever hub should be 2-1/2 inches (63 mm) above the seat.
Using the template provided, cut the appropriate mounting hole in the panel
as shown in Figure 7.