Table of Contents
Advertisement
3.0 - Configuration & Assembly
Upon initial receipt of the #FT-C70 system inspect the packaging for any evidence that the product may have been
damaged in shipment. While unpacking the product, inspect all of the components for damage. If damage to any of
the components is discovered, DO NOT USE THE PRODUCT! Alert the shipping carrier immediately of the damage
to the shipment.
Item
Part No.
3A
500204-001
3B
500196-001
3C
121569-001
3D
118283-002
4A
500426-WT1
4B
500572-001
4C
500408-001
The #FT-C70 is normally shipped within two separate boxes.
One box will contain the Base Assembly (#500019-001) and the
other box will contain the tower assembly (#500573-001).
Ensure that all components of the system are present upon
unpacking of the system. A simple assembly process is required
in order to mount the tower assembly to the base assembly;
1. Insert the tower into the base assembly.
3. Align the holes on the on the tower with the holes on the base
assembly by rotating the tower section by hand. Then insert
the 1/2" Pin (#2) to secure the tower to the base.
**Refer to parts list above if replacement parts are required.
Replacement parts can be ordered from the T.A. Pelsue Com-
pany at 800-525-8460.
Page 8
Description
Ring - Tri Anchor
Collar - Anchor Ring Retainer
Screw - Socket Head Cap
Washer - Flat
Screw Peg - T-Bar
Pin & Lanyard, 3/4" x 6"
Pin & Lanyard, 1/2" x 4-1/2"
Qty.
1
1
4
4
2
1
1
Figure 3.0: #FT-C70
Diagram & Parts List
500714-001 - Product Manual - #FT-C70 Carbon Fiber Fall Arrest Tower - Revision 02 - 2015-03-06
Advertisement
Table of Contents
