Dometic DM2672 Operating Manual page 9

4.3 Removing and replacing the shelves
4
Screwdriver
➤ Remove the shelf locks by inserting the tip of a flat-
bladed screwdriver into the slot in the locks.
➤ Turn the screwdriver counterclockwise and remove
the shelf locks from the wire shelf.
➤ Slide the shelf to the left until the plastic caps
disengage.
➤ Tilt the shelf to one side at an angle while pulling
forward.
4.4 Adjusting the thermostat
I
DM2682, DM2683, DM2882: The thermostat controls both the gas and electric operation. After the
initial start-up, adjust the thermostat to the desired temperature setting.
➤ Press the temperature selector button until the lamp at the desired setting is illuminated.
I
DM2672, DM2872: The temperature is controlled by a factory-preset temperature setting.
4.5 Using the ice maker (if equipped)
I
Read before proceeding:
• The first few cycles may produce small ice cubes due to air trapped in the water lines.
• If ice cubes remain too small or stick together, refer to "Adjusting the ice cube size" on page 10.
➤ Discard the first container of ice cubes if the water system has been winterized or out of use for several weeks.
9
Shelf
Shelf Lock
➤ Reposition the shelf in the desired location.
➤ Insert the ends of the wire shelf on the left-hand
➤ Slide the plastic caps into the holes of the wall.
➤ Snap the shelf locks back onto the wire shelf.
5
Cap
side and slide the shelf into the holes on the right-
hand side.
Refrigerator
Shelf
EN