T.J.M. 9000lb Fitting Instructions Manual page 8

89676 06-07-2011
Product:
5. Line the 10 holes, ensuring that the gasket is
also lined up between the gearbox foot casting
& gearbox housing.
6. Tighten all 10 allen head cap screw in a
diagonal sequence.
7. Carefully assembly the gearbox back into the
cable drum, ensuring the sun (centre) gear is
lined up in the cable drum.
8. Refit & tighten the two allen head cap screws to
the tie rods.
9. Check the operation of the clutch handle to
ensure gearbox engages & fit winch to bar.
For further information contact T.J.M. Head Office on (07) 3865 9999. Distributors Australia wide.
ELECTRIC WINCH
9000lb 9500lb
Page 8 of 17
12000lb
Diagram 5.
Diagram 6.
Diagram 7