Changing The V-Belt - Makita DCE090 Instruction Manual

Changing the V-belt

Remove the battery cartridge and the wheel.
1.
2. Loosen the hex socket bolts using the hex wrench
and then remove the cover .
1
► 1 . Hex socket bolt 2. Cover
While strongly twisting the V-belt so that its inner
3.
side faces up as shown in the figure, turn the bolt on the
pulley (large) clockwise using the box wrench.
The V-belt will deviate from the track and come off as
you turn the bolt.
1
► 1 . V-belt 2. Pulley (large) 3. Box wrench
NOTICE:
Never turn the box wrench counter-
clockwise. Doing so loosen the bolt on the pulley
(large) and result in poor performance.
Hook the new V-belt to the pulley (small). Put the
4.
other end of the V-belt onto the pulley (large) so that
it is partially hooked on the forefront rail of the pulley.
(You don't have to hook the V-belt to all of the rails on
the pulley at this stage). After that, turn the bolt on the
pulley (large) clockwise using the box wrench.
The V-belt will get on the track as you turn the bolt.
1
2
► 1 . Pulley (small) 2. Pulley (large) 3. Box wrench
Make sure that all the guides on the internal circle of the
V-belt fit into the rails on the pulleys. All the rails on the
pulley must support the guides on the V-belt. If there is
a rail which does not support the guide, the V-belt is not
properly installed.
3
2
► 1 . Rail on the pulley 2. Guide on the V-belt
14 ENGLISH
1
2
1
2
3
2