Juniper EX8200 Series Quick Start Manual page 2

2
Connecting Power to an EX 8200 series Switch
Flip the Enable switch, which is next to the appliance inlet on the power supply
3.
faceplate, to the Standby position.
Squeeze the two sides of the power cord retainer clip, and insert the L-shaped
4.
ends of the clip into the holes in the bracket on each side of the AC appliance
inlet on the AC power supply faceplate. See Figure 1 on page 2.
Figure 1: Power Cord Retainer in an AC Power Supply
Locate the power cord or cords shipped with the switch; the cords have plugs
5.
appropriate for your geographical location.
Insert the coupler end of the power cord into the AC appliance inlet on the AC
6.
power supply faceplate.
NOTE: If the power cord tray is installed, you can thread the power cord through the
power cord tray. See Figure 2 on page 3.
Push the cord (close to the coupler end ) into the slot in the adjustment nut of
7.
the power cord retainer. Rotate the nut until it is tight against the base of the
coupler and the slot in the nut is turned 90° from the top of the switch. See
Figure 2 on page 3.
If the AC power source outlet has a power switch, set it to the OFF (0) position.
8.
Insert the power cord plug into an AC power source outlet.
9.
If the AC power source outlet has a power switch, set it to the ON (|) position.
10.
Verify that the INPUT OK LED on the power supply faceplate is lit and is on
11.
steadily.
12. Flip the Enable switch on the power supply faceplate to the ON position.
Repeat steps 2 through 12 for the remaining power supplies.
13.