Advertisement
Mode Setting
Function
1
Direct
2
Latched
3
Timed 5 seconds
4
Timed 10 seconds
5
Timed 15 seconds
6
Timed 20 seconds
7
Timed 25 seconds
8
Timed 30 seconds
9
Timed 35 seconds
10
Timed 40 seconds
11
Timed 50 seconds
12
Timed 1 minute
13
Timed 2 minutes
14
Timed 3 minutes
15
Timed 4 minutes
16
Timed 5 minutes
17
Timed 10 minutes
18
Timed 15 minutes
19
Timed 20 minutes
20
Timed 30 minutes
21
Timed 1 hour
22
Timed 2 hours
23
On Only
24
Off Only
Table 1- Settings for use with other
EnvirON devices
Your EnvirON Switch 125 contains no user serviceable parts. If repair is necessary the unit should be
returned to Pretorian Technologies or an authorised distributor.
Your EnvirON Switch 125 is warranted against defects in manufacturing and component failure. The unit
is designed for domestic and educational applications. Use outside these areas will invalidate the
warranty. Unauthorised repair or modification, mechanical abuse, immersion in any liquid or connection
to incompatible sources of power will also invalidate the warranty.
Infra-Red Devices
If you are going to use your switch to control an infra-red device
such as a TV, you will need to pair it with an EnvirON Hub. You
must then choose which Mode to set the switch to in order to
achieve the required action. The switch will then send the
relevant information to Hub wirelessly and Hub will convert it
to infra-red for the TV.
You should already have programmed the required infra-red
codes into Hub and also written them onto the provided
Infra-Red Chart. If not, please do this now, by reference to the
Hub instruction booklet, before proceeding.
Now look down the entries in the Infra-Red Chart and choose
the function you would like to assign to the switch. For
example, it may be Power On/Off or Channel Up. Read the Code
number for that infra-red function and set the switch Mode to
the same number.
Let's suppose we want to set the switch to Channel Up, which
according to the Infra-Red Chart is on Code 2. Then press the
Mode button [2] repeatedly until you see '2' appear on the
display [3]. After a few seconds of making no further changes,
the display goes blank to save power and the new setting is
retained in the switch's memory even if the batteries are
removed or run flat.
The switch will now instruct the TV to increase the channel
number each time it is pressed, via Hub.
Your EnvirON Switch 125 has industry-standard mounting
holes to allow it to be mounted on a mounting system or fixed to
a surface to prevent it moving around. The tapped holes require
M4 set screws.
Mounting
Maintenance.
Warranty
Advertisement
