Koala Kare KB200 Installation And Operation Instructions Manual page 5

KB200
Important:
In Step 3, all SIX screws
provided must be mounted
to the chassis to ensure
proper load bearing
capacity!
Installation Instructions
4
Step 3. Mount Bed and Chassis
Use only screws and hardware appropriate for the
type of wall where the baby changing station is
being mounted. Tighten top two screws so that they
are flush with the wall. Use the four lower holes as
a guide to mark and drill pilot holes. Use remaining
four screws and four washers to complete
installation of bed and mounting bracket. Insert
washers over lower four screws. All SIX screws and
four washers must be mounted to the chassis.
Step 4. Install Liner Dispenser
Ensure liner dispenser is free from damage.
Remove key, unlock, and open liner dispenser
lid. This will expose liner dispenser mounting
holes. Line up dispenser mounting holes
onto chassis and secure with the four screws
provided. Close and lock the liner dispenser
door.
Step 5. Complete Installation
Clean work area and inspect unit to ensure it
opens and closes smoothly. Give Operator Kit
and key to the facility operator. Replacement
parts and additional liners can be purchased
from your local distributor or by calling Koala at
1.303.539.8300.