How to Perform a Cable Test
•
Power on the Cable Prowler.
•
Connect a network, coax, or telephone cable to the appropriate connector
on the top of the Cable Prowler.
(Warning! Do not plug an RJ11 cable directly into the Cable
Prowler! A standard RJ11 cable will damage the Cable Prowler's
RJ45 jack. Use the included RJ adapter patch cable that is
included with the cable Prowler.)
•
Press the enter button to display the cable test menu. The Cable Prowler
will automatically perform a test upon entering the cable test menu.
•
To test coax or telephone cable, press the coax or telephone soft key.
•
If a remote is NOT being used (one ended test), the Cable Prowler will
test the length of each pair, opens, shorts, or split pairs. Performing a
one ended test will not verify connectivity on the opposite end of the
cable.
•
If a remote is being used, connect the remote to the opposite end of the
cable.
•
To calibrate the VOP, connect a known length of cable to the Cable
Prowler and press the up/down/left/right buttons to increase or
decrease the VOP. Press the left and right buttons to select and change
the VOP one digit at a time.
•
While adjusting the VOP, press the test button every so often until the
length of the cable is displayed.
•
Press the green test button
perform additional tests.
•
To save a cable test, press the save icon.
•
Use the arrow buttons and the enter button to name the cable test file.
•
Press the save icon to save the cable test file.
www.platinumtools.com
Distribution:
PureLink GmbH
or the loop mode soft key
Available from B2B Online Portal
to
3