Toro REELMASTER 4500-D Operator's Manual page 15

IMPORTANT: The cam lever nut (Fig. 9 inset) can be
tightened if the limiter stop will not hold traction pedal in
desired position.
Transport Latches (Fig. 9 and 10)—Latches secure the cutting
units in upright position for transport. The latch for the front
cutting units is foot-operated (Fig. 9). Hand-operated latches
control the center and outside cutting units (Fig. 10).
Adjust the nut for traction pedal resistance.
Cutting Unit Lift Controls (Fig. 11)—The two outside
levers raise and lower the two outside cutting units. The cen-
ter lever raises and lowers the two front and the center cutting
units. The engine must be running to lower the cutting units.
When the cutting units are lifted, the reels automatically stop.
Do not allow the levers to snap-back to neutral, or the cutting
units may not float freely.
Cross Cut Link (Fig. 11)—Used with the center cutting unit
lift lever and the mow/Backlap lever when cross cutting the
turf.
Coolant Temperature Gauge (Fig. 11)—Indicates tempera-
ture of system coolant.
Engine Override Button (Fig. 11)—When the button is
depressed, the engine can be operated after it has overheated
and automatically been stopped by the electrical safety sys-
tem. Use only for short intervals.
Fuel Level Gauge (Fig. 11)—Indicates the amount of fuel in
the tank.
Circuit Breakers (Fig. 11)—The main circuit breaker (40
amp) protects the main engine electrical circuits and options,
such as headlights. The auxiliary breaker (10 amp) protects
the wiring for the indicator lights and switches. Push the but-
ton to reset the breakers.
Hour Meter (Fig. 11)—Indicates total hours that the machine
has been operated. Note: Lines circling in the small window
at the left side of gauge indicate that the hour meter is operat-
ing.
Engine Preheat Indicator (Fig. 11)—Burns brightly when
the glow plugs are heated sufficiently.
Engine Preheat Switch (Fig. 11)—For cold starts, push and
hold the switch until the indicator glows brightly.
Key Switch (Fig. 11)—This switch has three positions: OFF,
ON and START. Turn the key to START and release it when
the engine begins running. To stop the engine, turn the key to
Figure 9
1. Top of the traction pedal—forward
2. Bottom of the traction pedal—reverse
3. Speed limiter
4. Transport latch—front cutting units
Figure 10
1. Center cutting unit latch
2. Outside cutting unit latch